Aprilia Consumer Service Spa
Technical Service and Training
Release 4 july 99
This material is didactic and
may be changed following the technical
development of the product
2-If everything is functioning perfectly, the following figures may appear on the display:
-1, 0, 1 (throttle valve opening standard values – SEE CO SETTING)
3- If there are any faults, the fault codes will appear in sequence. The sequence will keep repeating
until you exit the Dealer Mode.
!!!! AFTER REPAIRING THE FAULT SWITCH THE BIKE ON AGAIN TO CHECK
IMPORTANT NOTES:
Whether or not the bike can be turned on in the Dealer Mode depends on the type of fault.
The ECU must be on for the fault codes to be saved; if the bike is switched off (STOP Condition) the codes
memory will be erased
There is no SW/HW control on the injectors
To Next Page
Loading...
Need help?
General
