Argo Service Manual Electrical System
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
ES-11
Installing the Lens Assembly (Conquest Models from CB12581)
1. Install the rubber headlamp bezel into the headlamp opening. Photo ES-7
2. Install the bulb into the headlamp housing. Insert and turn 1/4 turn clockwise.
Photo ES-8
3. Snap the lens assembly into the rubber headlamp bezel.
ES-7 ES-8
Headlamp Removal (Earlier Vanguard2 & Vanguard Models)
On Vehicles manufactured prior to S8131 & SN8138:
1. Remove the engine access cover.
2. Disconnect the battery.
3. Using a screw driver, remove the 4 screws holding the headlamp rim to the upper
body.
4. Pull the headlamp from the body.
5. Using a screwdriver, disconnect the wire leads from the headlamp.
6. Inspect the rubber gasket seal.
Headlamp Installation (Earlier Vanguard2 & Vanguard Models)
1. Seat the rubber seal into the headlamp opening in the vehicle.
2. Fasten the wire leads to the headlamp with a screwdriver.
3 Seat the headlamp into the rubber seal and install the rim fastening it securely with
the 4 screws.
4. Reconnect the battery
5. Install the engine access cover.
To Next Page
Loading...
Need help?
General
