Argo Service Manual Electrical System
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
ES-13
Removing the Starter (Conquest Models)
1. Perform the servicing procedure, Removing the Firewall, in section VB of this
service guide.
2. Perform the servicing procedure, Removing the Drive Belt, in section CS.
3. Perform the servicing procedure, Removing the Driven Clutch, in section CS.
4. Locate the starter relay wire and main power cable at the solenoid of the starter
motor and disconnect. Photo ES-12 The solenoid is fastened to the top of the
starter
The Kawasaki starter motor is located between the engine and transmission near the
brake cooling duct. Photo ES-11
ES-11 ES-12
5. Loosen off the bolts securing the brake cooling duct to the power pack frame and
slide the brake cooling duct towards the transmission as far as possible.
6. Locate the 2 bolts securing the starter motor to the mounting bracket and remove.
You will need to use a long extension and socket to reach the heads of the bolts.
Photo ES-13
7. Maneuver the starter motor and solenoid out from the mounting bracket, and turn
vertically to pull up between the engine and transmission. Photo ES-14
ES-13 ES-14
To Next Page
Loading...
Need help?
General
