Argo Service Manual Electrical System
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
ES-5
General Instructions
Detailed information on standard workshop and safety procedures, and general
servicing operations is not included in this manual, which has been prepared to assist
qualified service personnel. ODG assumes no responsibility or liability for
PERSONAL INJURY or VEHICLE DAMAGE which results from any servicing
procedure performed, including those instructions outlined in this manual. Before
performing a servicing operation, an individual must have determined to his/her
satisfaction that a personal injury or vehicle damage will not result from the
servicing procedure or tools selected.
• Always disconnect the battery when servicing any electrical component.
• Never weld on the vehicle without first disconnecting both positive and negative
battery cables. Make sure the part you are welding is properly grounded.
• Connecting booster cables to start your vehicle is not a recommended practice.
Damage to engine electrical components could occur.
• Connect switch terminals properly, especially the ground wire.
Battery fluid contains sulphuric acid. If battery fluid comes in contact with skin or
eyes, flush thoroughly with water. If swallowed, call physician or poison control
centre immediately. KEEP AWAY FROM CHILDREN. Serious personal injury can
occur. Always wear rubber gloves and safety glasses when servicing the battery.
Batteries can explode and cause serious personal injury if exposed to flame or
sparks. Never smoke while servicing the battery.
To prevent damage to the electrical system: