14 /
INSTALLATION
WARNING!!
THE INSTALLATION AND FIRST IGNITION OF
THE APPLIANCE MUST BE PERFORMED BY
QUALIFIED PERSONNEL IN COMPLIANCE
WITH CURRENT NATIONAL REGULATIONS
REGARDING INSTALLATION, AND IN
CONFORMITY WITH ANY REQUIREMENTS
ESTABLISHED BY LOCAL AUTHORITIES
AND PUBLIC HEALTH ORGANISATIONS.
Before installing the appliance
Theapplianceheatswatertoatemperaturebelowboiling.
It should be connected to a a domestic water mains
supply,thatmustcorrespondinsizetotheperformance
anditspoweroftheappliance.
Beforeconnectingtheappliance,itisrstnecessarytoperform
thefollowingoperations:
- Carefully wash the system piping in order to remove any
screw thread or welding residues, or any dirt which might
preventtheappliancesfromoperatingcorrectly.
- Makesurethattheapplianceissetupforoperationwiththe
typeofgasavailable(readtheinformationonthepackaging
labelandontheboilerdataplate).
-Makesurethattherearenoobstaclesinsideueexhaustand
thatitdoesnotcontainanydischargefromotherappliances,
unless the ue is meant to serve more than one user (in
accordancewithcurrentlegalrequirements).
- Wherethereisalreadyaconnectiontoexistingueexhausts,
check that these exhausts have been perfectly cleaned
and are without residues, because any disconnection
couldobstructthepassageoffumesandcreatepotentially
dangeroussituations.
- Makesurethat,whereunsuitableueexhaustsareattached,
theyhavebeenducted.
- In areas with particularly hard water, limescale may build
upon the componentsinsidethe applianceandreduce its
overallefciency.
B11bs-type appliances are open-chamber versions
designedtobeconnectiontoauegasdischargeduct
whichreleasesfumestowardstheoutside;combustionair
istakendirectlyfrominsidetheroominwhichtheboiler
isinstalled.
Fluegasisdischargedthroughanaturaldraughtsystem.
THIS TYPE OF APPLIANCE CANNOT BE INSTALLED
IN A ROOM THAT DOES NOT MEET APPROPRIATE
VENTILATION REQUIREMENTS.
So that the normal operation of the appliance is not
compromised,the placein whichit isinstalled mustbe
suitable with regard to the operating limit temperature
valueandtheapplianceshouldbeprotectedsothatitdoes
notcomeintodirectcontactwithatmosphericagents.
The appliance must be installed on a solid, non-
combustible,permanentwalltopreventaccessfromthe
rear.
When creating a space for the boiler, the minimum
distances(whichensurethatvariouspartsoftheappliance
maybeaccessedafterithasbeeninstalled)shouldbe
respected.
WARNING!!
NO INFLAMMABLE ITEMS SHOULD BE LEFT
IN THE VICINITY OF THE APPLIANCE.
MAKE SURE THE INSTALLATION SITE
AND ANY SYSTEMS TO WHICH THE
APPLIANCE MUST BE CONNECTED ARE
FULLY COMPLIANT WITH THE CURRENT
APPLICABLE LEGISLATION.
IF DUST AND/OR AGGRESSIVE VAPOURS
ARE PRESENT IN THE ROOM IN WHICH IT IS
TO BE INSTALLED, THE APPLIANCE MUST
OPERATE INDEPENDENTLY OF THE AIR
INSIDE THE ROOM.
Installation location
Observetheregulationsinforce,whendecidingwhereto
installthedevice.
Install the appliance in a PERFECTLY VERTICAL
POSITION.
Thedevicemustnotbeinstallednearheatsources.
Do not install the device in environments where
temperaturesmayreach0°C
Forinstallationinsidefurniture,considerthatthemaximum
temperatureofthedevicejacketislowerthan85°Cand
distancesrequiredformaintenancemustberespected.
Gas connection
Theappliancewasdesignedtousegasesbelongingto
thecategoriesasshowninthefollowingtable.
COUNTRY MODEL CATEGORIES
FAST R X ONM11EU
FAST R X ONM14EU
Make sure, using the labels on the packaging and the
dataplateontheapplianceitself,thattheapplianceisin
thecorrectcountryandthatthegascategoryforwhich
the appliance was designed corresponds to one of the
categoriesavailableinthecountrywhereitwillbeused.
The gas supply piping must be created and measured
outincompliancewithspeciclegalrequirementsandin
accordance with the maximum power of the appliance;
youshouldalsomakesurethattheshut-offvalveisthe
rightsizeandthatitisconnectedcorrectly.
Before carrying out the installation, it is recommended
that the fuel pipes are cleaned thoroughly in order to
removeanyresidueswhichcouldpreventtheappliance
fromoperatingcorrectly.
Checkthatthesuppliedgascorrespondstothetypeof
gasforwhichtheappliancewasdesigned(seethedata
platelocatedontheapplianceitself).
II2H3+