8
Mounting
The electric radiator should be fixed to the wall by the adjustable brackets supplied with the
heater, using the cardboard template printed on the box.
If for any reason cardboard template is missing, you can follow the instructions below:
1. Place the two metal brackets provided on the floor and against the wall as shown in
image 1 below. Ensure the MB stamp on the metal bracket is at the top.
2. Check Table 1 for the “A” distance between the brackets for your LIFESTYLE model.
3. Mark the small hole in the metal brackets on the wall with a pencil. These two marked
points determine the position of the two lower drill holes.
1
4. With the help of a level, position the brackets matching their lower holes with the
previously marked points and mark the upper holes with the pencil.
5. Drill the 4 marked holes. The grey plugs supplied require
an 8mm hole.
6. Insert the grey plugs into the pre-drilled holes. Screw the
metal brackets to the wall with the screws provided.
Model A (mm)
LIFESTYLE 500 160
LIFESTYLE 750 320
LIFESTYLE 1000 320
LIFESTYLE 1500 560
LIFESTYLE 1800 720
To Next Page
Loading...
Need help?
General
