4 Elektronikon™ Touch controller
4.1 Controller
The Elektronikon™ Touch controller
Introduction
The controller has the following functions:
• Controlling the unit
• Protecting the unit
• Monitoring components subject to service
• Automatic Restart After Voltage Failure (ARAVF)
Automatic control of the unit
The controller maintains the net pressure between programmable limits by automatically loading
and unloading the unit (fixed speed units) or by adapting the motor speed (units with frequency
converter).
A number of programmable settings, e.g. the unloading and loading pressures (for fixed speed
units), the setpoint (for units with frequency converter), the minimum stop time, the maximum
number of motor starts and several other parameters are taken into account.
The controller stops the unit whenever possible to reduce the power consumption and restarts it
automatically when the net pressure decreases. If the expected unloading period is too short, the
unit is kept running to prevent too short standstill periods.
It is possible to program a number of time-based commands for automatic start/stop.
Take into account that a start command will be executed (if programmed and activated),
even after manually stopping the unit.
Instruction book
2920 7118 31 43
To Next Page
Loading...
Need help?
General
