3.14 Test menu
Control panel
Function
To carry out a display test, i.e. to check whether the display and LEDs are still intact.
Procedure
Starting from the Main screen (see Main screen menu):
• Press the key ‘Menu’ (F1).
• Press arrow down key (1) until ‘Test’ is followed by a horizontal arrow.
• Activate the menu by pressing the key (2).
• The option ‘Display test’ will be followed by a horizontal arrow.
• To test the display, press the key (2). During testing, the regulator will generate a series of patterns on the
display which enable the operator to check that each pixel still functions normally; at the same time the
LEDs are lit.
3.15 Modify parameters menu
Function
To modify a number of programmable settings:
• Compressor/motor settings (see section Modifying compressor and motor settings).
• Parameters (see section Modifying parameters).
• Protections (see section Modifying protections).
• Service plan settings (see section Modifying service plan settings).
• Clock function settings (see section Modifying clock function settings).
• Configuration settings (see section Modifying configuration settings).
Instruction book
2920 1634 04 39
To Next Page
Loading...
Need help?
General
