Checking the safety straps
♦
Check the safety straps on the front and back of
the machine. Replace if they are damaged.
♦
Check the screws and nuts on the safety straps,
if necessary tighten or replace.
Check the machine's controls
1. Check that the throttle control (A) is not damaged
and does not jam.
2. Lubricate the controls (A, B) if necessary.
Cleaning the machine
♦
Do not spray water directly onto electrical
components or the instrument panel.
♦
Place a plastic bag over the fuel filler cap and
secure with a rubber band. (This will prevent water
from entering the venting hole in the filler cap.
Otherwise this could cause operational
disturbances, such as clogged filters.)
NOTICE Never aim a water jet directly at the fuel
filler cap. This is particularly important when using a
high-pressure cleaner.
After the first 20 hours of
operation
Maintenance routines:
♦
Change the engine oil. See the engine manual for
more information.
♦
Clean and refit air filter.
♦
Check the engine speed.
♦
Check and adjust valve clearances. See the
engine manual for more information.
Every 100 hours of operation
Maintenance routines:
♦
Check the shock absorbers.
♦
Check the engine speed.
♦
Check the V-belt.
CAUTION Cover the V-belt
Running a machine without the protective cover over
the V-belt may cause trapping or machine damage,
which can cause injury.
► Never run the machine without the protective cover
over the V-belt.
► Stop the engine before removing the protective
cover.
Checking the V-belt
The V-belt must be checked and adjusted by
authorized service personnel.
NOTICE An over tensioned v-belt can damage the
machine.
27© 2016 Construction Tools EOOD | No. 9800 1721 01 | 2016-04-07
Original instructions
Safety and operating instructionsLG 504
To Next Page
Loading...
Need help?
General
