Atlas Copco Power Focus 600 User Manual

EN Power Focus 600
44
© Atlas Copco Industrial Technique AB - 9836 4954 01
Output signals
Output signal Description
Tightening OK Tightening OK tells the user that the result of the
tightening is within the specified limits.
Tightening NOK Tightening NOK tells the user that at least one result
of the tightening is within the specified limits.
Low torque Torque result is lower than minimum torque limit.
High torque Torque result is higher than maximum torque limit.
Trigger pressed Indicates that the tool trigger has been pressed.
Direction ring CW
Direction ring CCW
Tool tightening Indicates that the tool is tightening.
Tool loosening Indicates that the tool is loosening.
Tool running Indicates that the tool is rotating (clockwise [CW] or
counter-clockwise [CCW]).
Tool rotation CW Tool rotation direction is CW for right-handed
threaded screws.
Tool rotation CCW Tool rotation direction is CCW for left-handed
threaded screws.
Thread direction CCW
Tightening is locked
Loosening is locked
Batch done The batch counter is equal to the batch size number.
Result can be OK or NOK.
Batch running Indicates that a batch in a batch sequence is running.
Test output signal
Max consecutive NOK reached
Batch completed OK Batch finished with status OK.
Batch completed NOK Batch finished with status NOK.
Bistable relay
Controller switched on
Carrier in station
Enable external scanner
Batch sequence completed OK Batch sequence finished with status OK.
Batch sequence completed NOK Batch sequence finished with status NOK.
Batch sequence running A batch sequence is selected and running.
Batch sequence completed The batch sequence counter is equal to the batch se-
quence size. Result can OK or NOK.
Generic I/O 1
Generic I/O 2
Generic I/O 3
Generic I/O 4
Generic I/O 5
Generic I/O 6

Atlas Copco Power Focus 600 Specifications

General

Brand	Atlas Copco
Model	Power Focus 600
Category	Controller
Language	English