Atlas Copco Power Focus 600 User Manual

Power Focus 600 EN
© Atlas Copco Industrial Technique AB - 9836 4954 01
9
Navigation
You navigate in the web interface by using the arrow keys on your keyboard.
To select options press ENTER or use the right arrow key, and to enter or con-
firm data in a text box, press ENTER.
Menu overview
The controller has up to eight menus where you can configure tightenings and
hardware accessories, perform tool maintenance, administer software and view
reports.
Note! The Batch menu and the Accessories menu are only
available with the Station control IAM. See section
IAM (Intelligent Application Module) [Page000] for
more information about IAM specifications.
{ , : profile4 in element [table]}
Tightening Batch Tool Controller Accessories Reports Settings
Psets Scanner Tool informa-
tion
IAM Internal I/O Results Language
Batch and
Batch se-
quence
Start source Software acti-
vation
I/O Expander Events Torque units
Calibration Software up-
date
Stacklight NOK ratio Date and time
Motor tuning Hardware
info.
Operator
panel
Network
Maintenance Export/Import Socket selec-
tor
Result view
PIN
Tightening menu
The Tightening menu lists the tightening configura-
tions (Psets) stored in the controller. Here you can
configure the Psets. Learn more about how to set up
and configure a tightening in section Tightening setup
[Page000].
Batch menu
The Batch menu lists the batch programs (Batch se-
quences) stored in the controller. If using a scanner
with the tool, this is where the scanner is configured.
Learn more about how to set up and configure a batch
sequence in section Batch [Page000].
Note! The controller must be equipped with a Station con-
trol IAM to be able to access batch functionalties.

Atlas Copco Power Focus 600 Specifications

General

Brand	Atlas Copco
Model	Power Focus 600
Category	Controller
Language	English