- 43 -
2. Changing the pressure of a preset
The operator can adjust the active preset as
follows.
In the Main view when the operator presses the
enter button for 2 sec. The pressure setting will
light up in green when it is in edit mode.
By pressing the up and down buttons the pressure
setting can be increased or decreased in 0.1 bar
steps.
Pressing the enter button again confirms the
pressure setting and will leave the edit mode.
DURING OPERATION
Regularly carry out following checks:
1. Check all measurement views for normal
readings.
2. Avoid the engine running out of fuel.
Nevertheless, if this happens, fill the fuel tank and
prime the fuel system to speed up starting.
MAIN VIEW
LOADED
7.2
1424RPM 7.2bar1286h
40%
MAIN VIEW
LOADED
1424RPM 7.2bar1286h
40%
7.2
The doors must be closed during
operation and may be opened for short
periods only.
Be aware not to touch hot parts when the
door is open.
When the engine is running the air outlet
valves (ball valves) must always be in a
fully opened or fully closed position.
To Next Page
Loading...
Need help?
General
