- 48 -
STORAGE
Run the compressor regularly, e.g. twice a week, until
warm.
Load and unload the compressor a few times to
operate the unloading and regulating components.
Close the air outlet valves after stopping.
SERVICE PAKS
A Service Pak is a collection of parts to be used for a
specific maintenance measure.
It guarantees that all necessary parts are replaced at
the same time keeping down time to a minimum.
The order number of the Service Paks are listed in the
Atlas Copco Parts List.
SERVICE KITS
A service kit is a collection of parts to fit a specific
repair or rebuilding task.
It guarantees that all necessary parts are replaced at
the same time which improves the uptime of the unit.
The order numbers of the Service Kits are listed in the
Atlas Copco Parts List.
COMPRESSOR ELEMENT OVERHAUL
When a compressor element is due for overhaul, it is
recommended to have it done by Atlas Copco. This
guarantees the use of genuine parts and correct tools
with care and precision.
LIABILITY
The manufacturer does not accept any liability for any
damage arising from the use of non-original parts and
for modifications, additions or conversions made
without the manufacturer’s approval in writing.
If the compressor is going to be stored
without running from time to time,
protective measures must be taken.
Contact Atlas Copco.
DD6.book Page 48 Monday, November 10, 2014 11:25 AM
To Next Page
Loading...
Need help?
General
