Content
Mediant 800 Gateway & E-SBC | Hardware Installation Manual
Table of Contents
1 Introduction 1
2 Unpacking the Device 2
3 Physical Description 3
Physical Dimensions and Operating Environment 3
Front Panel Description 3
Ports and Buttons 3
LEDs Description 5
LAN Interface LEDs 5
FXS LEDs 5
FXO LEDs 5
BRI LEDs 6
E1/T1 (PRI) LEDs 6
STATUS LED 6
Power LEDs 7
Rear Panel Description 8
4 Mounting the Device 10
Desktop Mounting 10
Wall Mounting 10
19-Inch Rack Mounting 12
Using a Pre-Installed Rack Shelf 13
Using Mounting Brackets 13
5 Cabling the Device 15
Grounding and Surge Protection 15
Connecting to LAN 16
Connecting to Analog Devices 18
Connecting the FXS Interfaces 18
Connecting the FXO Interfaces 19
Connecting the FXS Analog Lifeline 20
ISDN BRI Interfaces 21
Connecting to BRI Lines 21
Connecting PSTN Fallback for BRI Lines 22
Connecting ISDN E1/T1 Interfaces 23
Connecting to ISDN PRI (E1/T1) Trunks 23
Connecting PSTN Fallback for E1/T1 Trunks 24
Connecting to a Computer for Serial Communication 25
Connecting the OSN Server 26
Connecting to Power 27
Connecting to AC Power 28
Connecting to DC Power 29
6 Maintenance 32
Replacing the Power Fuse 32
- v -
To Next Page
Loading...
Need help?
General
