Version 5.6 33 November 2008
Installation Manual 3. Configuring the Device
4. To change the IP address:
a. Press 1 followed by the pound key (#); The current IP address of the device is
played.
b. Press the # key.
c. Dial the new IP address. Use the star (*) key instead of periods (.), e.g.,
192*168*0*4, and then press # to finish.
d. Review the new IP address, and then press 1 to save.
5. To change the subnet mask:
a. Press 2 followed by the # key; The current subnet mask of the device is played.
b. Press the # key.
c. Dial the new subnet mask (e.g., 255*255*0*0), and then press # to finish.
d. Review the new subnet mask, and then press 1 to save.
6. To change the default Gateway IP address:
a. Press 3 followed by the # key; The current default Gateway address is played.
b. Press the # key.
c. Dial the new default Gateway address (e.g., 192*168*0*1), and then press # to
finish.
d. Review the new default Gateway address, and then press 1 to save.
7. Hang up the handset.
8. Access the device's Web interface with the new IP address you assigned.
Alternatively, initial configuration may be performed using an HTTP server, as discussed in
the Product Reference Manual ('Automatic Update Facility'). The Voice Menu may be used
to specify the configuration URL.
¾ To set a configuration URL, take these 8 steps:
1. Obtain the IP address of the configuration HTTP server (e.g., 36.44.0.6).
2. Connect a telephone to one of the FXS ports.
3. Lift the handset and dial ***12345 (three stars followed by the digits 1, 2, 3, 4, and 5).
4. Wait for the 'configuration menu' voice prompt to be played.
5. Dial 31 followed by the # key; the current IP address is played.
6. To change the IP address, perform the following:
a. Press the # key.
b. Dial the configuration server's IP address. Use the star (*) key instead of dots ("."),
e.g., 36*44*0*6, and then press # to finish.
c. Review the configuration server's IP address, and then press 1 to save.
7. Dial 32 followed by the # key, and then perform the following to change the
configuration file name pattern:
a. Press the # key.
b. Select one of the patterns listed in the following table (aa.bb.cc.dd denotes the IP
address of the configuration server):
To Next Page
Loading...
Need help?
General
