Installation Manual 42 Document #: LTRT-59809
MediaPack Series
3.7 Restoring Factory Default Settings
You can use the device's hardware Reset button to restore all the device's configuration
settings to factory defaults, including the device's IP address and Web interface's login user
name and password. These default settings include factory defaults as well as user-defined
defaults (refer to the device's User's Manual) defaults.
Note:
The device resets to the software version (cmp file) saved on its flash
memory.
¾ To restore the MP-124 to factory default settings, take this step:
With a paper clip or any other similar pointed object, press and hold down the Reset
button (located on the front panel) for about six seconds; the device restores to factory
default settings.
¾ To restore MP-11x to factory default settings, take these 3 steps:
1. Disconnect the Ethernet cable from the device.
2. With a paper clip or any other similar pointed object, press and hold down the Reset
button (located on the rear panel) for about six seconds; the Fail LED turns red and
the device restores to factory default settings.
3. When the Fail LED turns off, reconnect the Ethernet cable to the device.
3.8 Upgrading the Device
You can upgrade the device with the following files, using the device's Web interface:
Firmware (cmp) file using the Web interface's Software Update Wizard (refer to
'Upgrading Firmware Using Software Update Wizard' on page 42).
Auxiliary and ini files using the 'Load Auxiliary Files' page (refer to 'Upgrading the ini
and Auxiliary Files' on page 46).
Note: When upgrading the firmware (cmp), you can also use the Software Update
Wizard to load the ini and auxiliary files.
To Next Page
Loading...
Need help?
General
