CHAPTER6 Hardware Maintenance
Mediant 1000 Gateway & E-SBC | Hardware Installation Manual
● You can only replace a single module per hot-swappable module replacement
process.
● For hot-swappable module replacement, make sure that the module is replaced
with a module of the same interface type and same number of ports, and in the
same chassis slot. For example, a 2-port FXS module in Slot #1 must be
replaced with a new 2-port FXS module and inserted in Slot #1.
(French) Avertissement:
Remplacez le module par le même type de module et dans la même fente du châssis.
Par exemple, un module TRUNKS endommagé avec deux portées numériques dans
la Fente 1 doit être remplacé par un module TRUNKS avec deux portées numériques
dans la Fente 1.
If you are replacing a module with a module that supports a different interface (e.g.,
FXO instead of FXS) and provides a different number of ports, make sure that the
License Key installed on the device provides support for this added hardware
interface. For more information, contact your AudioCodes sales representative.
➢ To replace a front-panel I/O module:
1. (CRMX module replacement only) Make sure that you have a new License Key for the new
module. If not, ask your AudioCodes sales representative for the License Key.
2. (Non hot-swappable modules) Power down the device, and then continue with Step 4.
3. (Hot-swappable modules) Software-remove the module, using the device's Web interface:
a. Access the device's Web interface.
b. Open the page with the graphical display of the device:
◆ Version 7.2 and later: Monitor page (Monitor menu > Monitor tab > Monitor)
◆ Versions earlier than 7.2: Home page
c. Click the title of the module that you want to replace; the Remove Module button
appears:
Figure 6-7: Clicking Module Title
d. Click the Remove Module button; a message box appears requesting you to confirm
module removal.
- 61 -
To Next Page
Loading...
Need help?
General
