AutroMaster ISEMS
Installation and Commissioning Handbook, AutroMaster ISEMS - Integrated Safety and Emergency Management System,
116-P-AMASTER-INSTCOMM/IGB, Rev. C, 2016-05-20, Autronica Fire and Security
Page 51
4. AutroMaster ISEMS
4.1 Modifying the hosts-file
Before registering the software, the network has to be configured.
The hostname defined during installation of LINUX is assigned to the
loopback interface (127.0.0.1) by default. See the example below.
# Do not remove the following line, or various programs
# that require network functionality will fail.
127.0.0.1 AutroMaster-5000 localhost.localdomain localhost
To achieve a proper communication between, for example, Master
and Slave AutroMaster, the hostname must be assigned to the
computer’s IP-address. This is done by removing the hostname from
the Loopback interface and then adding the hostname on the next line
together with the computer’s IP-address. See the example below.
# Do not remove the following line, or various programs
# that require network functionality will fail.
127.0.0.1 localhost.localdomain localhost
192.168.1.1 AutroMaster-5000
When more computers are connected in a network, add the IP-
address and the hostname for each computer.
To Next Page
Loading...
Need help?
General