EasyManuals Logo
Home>Barco>Monitor>MDRC-2122 WP

Barco MDRC-2122 WP User Manual

Barco MDRC-2122 WP
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
7. Important information
7. IMPORTANT INFORMATION
7.1 Safety information
General recommendations
Read the safety and operating instructions before operating the device.
Retain safety and operating instructions for future reference.
Adhere to all warnings on the device and in the operating instructions manual.
Follow all instructions for operation and use.
Electrical Shock or Fire Hazard
To prevent electric shock or re hazard, d o not remove cover.
No serviceable parts inside. Refer servicing to qualied personnel.
Do not expose this apparatus to rain or moisture.
Type of protection (electrical):
Display with external power supply: Class I equipment.
Degree of safety (ammable a nesthetic mixture):
Equipment not suitable for use in the presence of a ammable anesthetic mixture with air or with oxygen
or nitrous oxide.
Non-patient care equipment
Equipment primarily for use in a health care facility that is intended for use where contact with a patient
is unlikely (no applied part).
The equipment may not be used with life support equipment.
The user should not touch the equipment, nor its signal input ports (SIP)/signal output ports (SOP)
and the patient at the same time.
Power connection Equipment with external 12 VDC power supply
Power requirements: The equipment must be powered using the delivered medical approved 12 VDC
(
) power supply.
The medical approved DC (
) power supply must be powered by the A
C mains voltage.
The power supply is specied as a part of the ME equipment or combination is specied as a ME
system.
To avoid the risk of electric shock, this equipment mu
st only be connected to a supply mains with
protective earth.
The equipment should be installed near an easily accessible outlet.
The equipment is intended for continuous operation.
Transient over-voltage
If the device is not used for a long time, disconnect it from the AC inlet to avoid damage by transient
over-voltage.
To fully disengage the power to the device, please disconnect the power cord from the AC inlet.
K5903049 EONIS 19/02/2014
23

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Barco MDRC-2122 WP and is the answer not in the manual?

Barco MDRC-2122 WP Specifications

General IconGeneral
BrandBarco
ModelMDRC-2122 WP
CategoryMonitor
LanguageEnglish

Related product manuals