41R5905753 /17 DPxK-19B/23B/P
Parts identification manual Lamp House
1
11
12
4 5 6
2
7
8
9
17
16
14
15
10
3
13
Image 4–3
1 Air inlet cathode cooling.
2 Adjustment screw horizontal lamp alignment.
3 Positioning pin.
4 Connection Lamp Info module.
5 Positioning pin.
6 UV blocker.
7 Cathode connection with SPG.
8 Anode connection with SPG.
9 Removable front cover.
10 Air out let.
11 Removable side cover.
12 Lamp Info module.
13 Lamp House fixation screw.
14 Adjustment screw horizontal lamp alignment.
15 Lamp cathode fixation screw.
16 Adjustment screw for lamp Z-alignment.
17 Adjustment screw vertical lamp alignment.
4.2 Supported xenon lamps for the S/M Lamp
House
Cathode adaptor
A cathode adaptor is required to mount the xenon lamp in the Lamp House. The cathode adapter has to be
mounted on the cathode side of the xenon lamp prior to mounting the lamp in to the Lamp House. The
purpose of the cathode adapter is to position the arc of the xenon lamp in the middle of the reflector inside the
Lamp House.
Image 4–4
1 Cathode adapter manual Lamp House (R865555K)
All lamps and adapters in the table below must be used with the S/M Lamp House (either manual
or motorized). Note that the maximum lamp power the projector delivers depends on the type of
projector and the installed lamp. Prior to install the lamp it's important to check with the
Communicator software if the lamp is listed in the list of supported lamps for this projector.
Lamp & Lamp House
To Next Page
Loading...
Need help?
General
