31
HOW TO FIT THROUGH 39” DOOR
Description:
The monitor surround assembly with wood can be removed from a Willy Crash game to allow the
game to fit through a narrow opening door.
Tools Needed:
# 2 Square bit screwdriver 7/16” Socket Wrench
Instructions:
Unplug the game’s power cord from the wall.
Unlock and remove the back door of the game.
Locate the access panel on the right side of the back of game.
Remove the 6 screws using a # 2 Square bit screwdriver. Unplug the HDMI cable
from the HDMI 1 slot and pull sticky tabs from the back of the monitor.
The 4 bolts in the recessed holes must be left in place.
Do not remove! They hold the monitor to the wood board.
Unplug the monitor power cord from the Y connector in
the back. Remove cable clamp to free monitor power
cord using a # 2 Square bit screwdriver.
Unplug the bottom 2 four pin molex connectors.
Tuck the light cables, HDMI cable, and the monitor power
cord inside the access hole so
it can be removed with the
wood and monitor.
Leave these
bolts in
place!!
The monitor wood frame will be attached to the monitor and the wood will come out
with the monitor as it is removed from cabinet.
The old monitor can now be removed from the cabinet:
Using 2 people - Remove the 4 nuts & washers with a 7/16” wrench.
Carefully pull the wood off the front of the cabinet and place on a soft flat surface.
Reinstall monitor onto cabinet using reverse process.
To Next Page
Loading...
Need help?
General
