• Operating the control unit with a detached CEE plug is only permiss-
ible if the mains supply can be isolated from all poles of the control
unit using an appropriate switch. The mains plug, or any switch used
as a substitute, must be easily accessible.
Caution
• The potential-free signal relay may only be used for
switching low voltage. The switching of mains voltage is
not permitted.
Commissioning notes
• The setting of the parameters, limit positions, jumpers and other op-
erator controls must only be carried out by trained personnel.
Caution
• The setting of the parameters and limit positions, and
the function of the safety devices must be checked by
trained technicians.
Intended use
The control unit in these instructions is exclusively designed for indoor use for the oper-
ation of roller doors, vertical lift gates, sectional doors, flexible (fabric) doors or indir-
ectly operated door systems.
This type of control unit must not be used in potentially explosive areas.
The mains cable and any other connected cables are not designed for carrying the
control unit. Therefore always carry the control unit by the housing.
Other applications, uses and modifications are not permitted in order to protect the
safety of the users and others, since these actions can impair the system’s safety and
carry the risk of personal injury and property damage. The manufacturer does not ac-
cept liability for damage or injury arising from such actions.
Always observe the information in these instructions when operating or repairing the
system. The manufacturer does not accept liability for damage or injury resulting from
improper use.
6
To Next Page
Loading...
Need help?
General
