© BEKA 201 All rights reserved5!
...a product of BEKA
The operating data base is opened and the last registered errors or warnings are displayed.
Date and time for occuring error is shown as well as for the reset of error.
Line related errors are directly indicated.
Fig. 25:
The display shows the number of current messages, message quantity and total number of messages.
If more error or warnings are shown, use the control buttons to scroll up or down. You can also display previous errors and
warnings (total number of message), by scrolling with the control buttons.
Press ESC to get out of the error and warning report.
7.7 Activation of the pump
After the first activation of voltage you have to select if the control unit shall start with a pulse off time or with a lubrication.
Second possibility would be to select if the current data shall be written in the memory. After a reactivation the data are
read from the memory and the cycle shall start from where it has been interrupted.
· Choose the requested option with the up and down buttons
· Confirm with OK
Fig. 26:
switch-on behaviour
lubrication
break
saved condition
*
message
Fehler kommt
error pressurization
line 1
ate:d
ime:t
107.1/178
20.01.14
10:41:24
Number of
current message
Quantity of
current messages
Total number of messages
24
To Next Page
Loading...
Need help?
General
