BFC VMC Series User Manual

5
HTE402559 18/47
After setting the “Frequency Range”, set the stroke following the procedure below.
Put some work pieces in the bowl or chute and set the stroke so that they are discharged
smoothly on the track.
Without the stroke sensor or pulling the plug connector of the stroke sensor off
VMC-controller, the running mode is “Constant Voltage” mode.
1. Dial “Selection Dial” and select
“Stroke” turning “Stroke” lamp on.
Stroke data appears
Selection Dial
Turning on
Dial
2. Push “Set” button and change the mode
“Indication” to “Adjustment”.
Blinking Push button
3. Dial “Setting Encoder” and set the value around 70 to 80 percent.
Push “SET” button to shift the blinking digit from decimals to units.
Push button
Blinking
Setting Encoder
Dial
Initial Setting
-Continued-
How to set the stroke on the Constant Voltage Mode
4. Push “Save” button to store the data having been set.
Push button Storing New data is stored

BFC VMC Series Specifications

General

Brand	BFC
Model	VMC Series
Category	Controller
Language	English