BFC VMC Series User Manual

5
HTE402559 20/47
4. Push “Set” button to change the mode from
“Indication” to “Adjustment”.
How to set the Stroke on
the
Constant Stroke mode
3. Dial “Selection Dial” to select “Function”.
1. On the beginning, “Stroke” is set on the “Auto-tuning” mode.
See “How to set the stroke on the auto-tuning mode”.
2. Push “Auto Freq” button more than three seconds
and change the mode from auto-tuning to constant stroke.
Push button
AUTO FREQ AUTO FREQ
Selection Dial
Turning on
Dial
Push button
Blinking
After setting the “Frequency Range”, set the stroke following the procedure below.
Put some work pieces in the bowl or chute and set the stroke so that they are discharged
smoothly on the track.
Initial Setting
-Continued-
push more than three seconds

BFC VMC Series Specifications

General

Brand	BFC
Model	VMC Series
Category	Controller
Language	English