BFC VMC Series User Manual

5
HTE402559 3/47
 Don’t apply VMC-controller to a piezo-electric type partsfeeder.
 Don’t use VMC-controller where inflammable material exists. It has not an
explosion-proof structure.
 You should fix the controller firmly on the rigid structure. Otherwise the operator
might be injured by falling down and/or abnormal operation of it.
 Don’t sprinkle VMC-controller with water and/or submerge it in water, or cause the
operator injury and/or get an electric shock.
 Before performing any maintenance work, such as opening cover, wiring, replacing fuse
and etc., the electrical supply must be disconnected at the safety disconnect switch.
The electrical circuit inside involves high voltage and the operator should get an
electric shock.
 The electrical power supply to VMC-controller must be made through a customer-supplied
safety disconnect switch mounted next to VMC-controller.
 Operate VMC-controller within the specified range in the contracted specifications,
or it causes it malfunction, damage and/or shorter life time.
 Don’t get on and/or put a thing on the controller, or it results injury by fall, and/or
damage and/or malfunction of it.
 Don’t bruise cords and/or leads. Bending by force, pulling, winding and/or clamping
them cause fire and/or getting an electric shock by leakage and/or mal-conduction,
and/or abnormal operation.
 Wire VMC-controller correctly consulting the “Instruction Manual”. Faulty wiring
causes damage and/or abnormal operation of it.
 Before supply VMC-controller electrical power, check the wiring.
 VMC-controller must be grounded properly without fail. Don’t operate it without
grounding.
Warning
Danger
Safety Instructions
-Continued-

BFC VMC Series Specifications

General

Brand	BFC
Model	VMC Series
Category	Controller
Language	English