G2S A20 / G2S C20 User Manual V1.0
16 / 39
11.7 Using the Cellular Module
For more details, please refer to the corresponding user manual.
11.8 Starting Treatment
Connect the device to a power outlet, press the Knob , and the device will start
delivering air.
WARNINGS!
• Be sure to follow your physician’s instructions on adjusting the settings! To order any
accessories not included with this device, contact your equipment supplier.
• DO NOT connect any ancillary equipment to this device unless recommended by BMC or
your physician. If you suffer from chest discomfort, shortness of breath, stomach bloating, or
severe headache when using the device, contract your physician or qualified medical
personnel immediately.
12. Routine Use
12.1 Connecting the Tube
Connect the power cord, power adapter, and tube properly according to the instructions in
the First Time Setup (Chapter 11). Connect the mask and headgear according to the user
manual for the mask.
CAUTION!
• Before each use, examine the tube for any damage or debris. If necessary, clean the tube
to remove the debris. Replace any damaged tube. Make sure that the mask does not leak.
12.2 Adjusting the Tube
Lie down on your bed, and adjust the tube so it is free to move if you turn during sleep.
Adjust the mask and headgear until you have a comfortable fit and until there are no airflow
leaks around the mask.
12.3 Turning on the Airflow
Press the Knob to turn on the airflow. The screen will display treatment pressure and
other information.
12.4 Heating the Water
Pay attention to the humidifier indicator lights when using the humidifier. The indicator lights
indicate the On / Off state of the humidifier. It is off when all indicator lights go out.
CAUTION!
• Observe the water level of the water chamber before using the humidifier. Make sure there
is sufficient water in the water chamber, and avoid heating the device with an empty water
chamber.
To Next Page
Loading...
Need help?
General
