114
1 Stud cap (not for wheels with
wheel stud cover)
2 Wheel stud for adapter
3 Adapter (supplied in toolkit)
To remove:
1 Turn the cap (1) slightly to the left
with the wheel stud wrench and
remove it.
2 Take adapter (3) from the car's
toolkit and insert it into the wheel
stud.
3 Unscrew the wheel stud (2).
After inserting and tightening the
wheel stud again, remove the adapter
and press on the stud cap.
The code number is embossed on the
front of the adapter. Please make a
careful note of this number and keep it
in a safe place, in case the adapter is
lost.
Manual release
Take the pull wire (arrow) out of the
luggage compartment trim and pull it
to the rear.
365de094
312de007
Thiefproof wheel studs Fuel filler flap
Online Edition for Part-No. 01 41 9 790 191 - © 12/98 BMW AG
To Next Page
Loading...
Need help?
General
