with Automatic Stability Control
(ASC)
OE
Initially, the ASC symbol
changes status. Press and
hold down button 1 until the
ABS warning light responds.
Under these circumstances
there is no change in the ASC
setting.
Release button 1 within two
seconds.
ABS warning light remains
ON.
The ABS function is deactiv-
ated.
Activate ABS function
Press and hold down button 1
until the ABS warning light
changes status.
ABS warning light goes out;
if self-diagnosis has not
completed it starts flashing.
Release button 1 within two
seconds.
The ABS warning light re-
mains off or continues to
flash.
The ABS function is activated.
You also have the option of
switching the ignition off and
then on again.
An ABS fault has occurred
if the ABS warning light
shows when the motorcycle ac-
celerates to a speed in excess
of 5 km/h after the ignition was
switched off and then on again.
BMW Motorrad ASC
with Automatic Stability Control
(ASC)
OE
Deactivate ASC function
Switch on the ignition.
You have the option of de-
activating the ASC function
while the motorcycle is on the
move.
4
43
z
Operation
To Next Page
Need help?
General
