Remove the key and close the
protective cap.
Securing motorcycle
for transportation
Make sure that all components
that might come into contact
with straps used to secure the
vehicle are adequately protec-
ted against scratching. Use
adhesive tape or soft cloths, for
example, for this purpose.
The motorcycle can topple
and fall on its side.
Secure motorcycle against top-
pling; this is best done with the
support of a 2nd person.
Push the motorcycle onto the
transportation flat and hold it in
position: do not place it on the
side stand or centre stand.
Risk of damaging compon-
ents.
Take care not to trap
components such as brake lines
or wires.
At the front, secure the straps
to the bottom fork bridge on
both sides and tighten the
straps.
At the rear, secure the straps
to the rear frame on both sides
and tighten the straps.
Tighten all the straps uniformly;
the vehicle's suspension should
be compressed as tightly as
possible front and rear.
6
74
z
Riding
To Next Page
Loading...
Need help?
General
