"Activation after ignition OFF" is
programmed.
Turn indicators flash once.
Alarm tone sounds once (if
programmed).
Alarm function is deactivated.
Conserving battery power
Approximately one hour after the
alarm is armed, the receiver for
the remote control in the anti-
theft alarm shuts down in order
not to draw power unnecessar-
ily from the battery. If you want
to deactivate the alarm function
after the receiver has shut down
in this way, you have to switch
the ignition on.
Programming
with anti-theft alarm (DWA)
OE
Programming options
You can customise the follow-
ing parameters of your anti-theft
alarm:
Confirmation alarm tone after
activation/deactivation of the
anti-theft alarm in addition to
visual confirmation by turn in-
dicators flashing
Rising and falling or intermittent
alarm tone
Automatic activation of the
alarm function after the igni-
tion is switched off
Default settings
The anti-theft alarm ships with
the following default settings:
Confirmation alarm tone after
activation/deactivation of the
anti-theft alarm: No
Alarm tone: Intermittent
Automatic activation of the
alarm function after the igni-
tion is switched off: No
Programming anti-theft
alarm
Deactivate the alarm function.
Switch on the ignition.
Press button 1 three times.
Acknowledgement tone sounds
once.
Within ten seconds, switch off
the ignition.
Press button 2 three times.
Acknowledgement tone sounds
once.
Within ten seconds, switch on
the ignition.
Acknowledgement tone sounds
three times.
5
58
z
Anti-theft alarm DWA
To Next Page
Loading...
Need help?
General
