with OE BMW Motorrad Inte-
gral ABS:
The cable of the ABS
sensor could chafe
through if it comes into
contact with the brake disk.
Make sure that ABS sensor
cable is routed correctly.
Carefully route ABS cable.
Install mounting screws 3.
Front brake caliper mounted
on wheel carrier ( 129)
Remove adhesive tape from
wheel rim.
Position cover 2.
Install screws 1.
Press the handbrake lever
firmly a number of times un-
til the resistance point is no-
ticeable.
with OE BMW Motorrad Inte-
gral ABS:
Switch on ignition.
Wait for the self-diagnosis.
Press the handbrake lever
firmly a number of times un-
til the resistance point is no-
ticeable.
Removing rear wheel
Place motorcycle on an
auxiliary stand; BMW rec-
ommends the BMW Motor-
rad rear wheel stand.
Install rear-wheel stand.
with OA Center stand:
Make sure ground is level
and firm and place motorcy-
cle on its center stand.
Remove bolt 1 of muffler
cover 2.
Pull cover towards rear.
7
104
z
Maintenance
To Next Page
Loading...
Need help?
General
