English – 16
1 270 020 Wen | (13.5.16) Bosch eBike Systems
Initial Operation
Requirements
The eBike system can only be activated when the following requirements
are met:
– A sufficiently charged eBike battery pack is inserted (see operating
instructions of the battery pack).
– The on-board computer is properly inserted in the holder (see “Inserting
and removing the on-board computer”, page English – 17).
Switching the eBike System On/Off
Options for switching on the eBike system:
– Place the on-board computer into the holder 4.
– When the on-board computer and the eBike battery pack are inserted,
briefly press the On/Off button 5 of the on-board computer.
– When the on-board computer is inserted, press the On/Off button of the
eBike battery pack (see battery pack operating instructions).
The drive is activated as soon as you step on the pedals (except for in the
push assistance function or in assistance level “OFF”). The motor output
depends on the settings of the assistance level on the on-board computer.
As soon as you stop pedaling when in normal operation, or as soon as you
have reached a speed of 25/45 km/h, the assistance from the eBike drive
is switched off. The drive is automatically re-activated as soon you start
pedaling again and the speed is below 25/45 km/h.
Options for switching off the eBike system:
– Press the On/Off button 5 of the on-board computer for at least
1 second.
– Switch the eBike battery pack off by its On/Off button (see battery pack
operating instructions).
– Remove the on-board computer out of its holder.
If no power is drawn from the drive for about 10 minutes (e.g. because the
eBike is not moving) or no button is pressed on the Nyon, the eBike system
will shut down automatically to save energy.
To Next Page
Loading...
Need help?
General
