English – 60
1 270 020 Wen | (13.5.16) Bosch eBike Systems
Maintenance and Cleaning
Please observe the operating and storage temperatures of the eBike com-
ponents. Protect the drive unit, on-board computer and battery against
extreme temperatures (e.g. from intense sunlight without adequate
ventilation). The components (especially the battery pack) can become
damaged through extreme temperatures.
An abrupt change of environmental conditions, can cause the screen to fog
up from inside. After a short time, a temperature adjustment takes place
and the fog disappears.
Keep the screen of your Nyon clean. Dirt can cause faulty brightness detec-
tion. The day/night switch-over in the navigation mode can be distorted.
Keep all components of your eBike clean, especially the battery-pack
contacts and corresponding holder contacts. Clean them carefully with a
soft, damp cloth.
Have your eBike checked by an expert at regular intervals. The on-board
computer displays a message telling you when the service date is due for
four seconds after switching it on. The bicycle manufacturer or dealer may
base the service date on the distance travelled and/or on a period of time.
Do not immerse any components, including the drive unit, in water or clean
them with pressurised water.
Clean your on-board computer using a soft cloth dampened only with
water. Do not use any detergents.
Have your eBike system checked by an expert at least once a year (includ-
ing mechanical parts, up-to-dateness of system software).
The bicycle manufacturer or dealer may also base the service date on the
distance travelled and/or a period of time. In this case, the on-board
computer displays a message telling you when the service date is due for
four seconds after each time it is switched on.
For service or repairs on the eBike, please refer to an authorised bicycle
dealer.
Have all repairs performed only by an authorised bike dealer.
To Next Page
Loading...
Need help?
General
