28
Operation
Removal lock
The control computer can be locked in the holder to prevent
removal.
• If you have no experience mounting bicycle components, have
your specialist dealer mount the removal lock.
1. Disconnect the holder from the handlebars.
2. Place the control computer in the holder.
3. Screw the blocking screw (M3 × 8 mm) into the threading of
the holder from below (see Figure. B-8).
4. Mount the holder back on the handlebars.
Blocking screw
Fig.: B-8 Example picture of the holder without control
computer.
Power supply
When the e-bike is switched on and the rechargeable battery is
charged, the inserted control computer is supplied with energy
via the e-bike rechargeable battery.
The control computer that has been removed is supplied with
power from an internal rechargeable battery.
If the internal rechargeable battery is weak when you activate the
control computer, “Attach to bike” will appear for 3 seconds in
the text display field (see Figure B-9). The control computer will
switch back off afterwards.
• Charge the control computer (see following chapter “Operation
> Control computer > Charging the control computer”).
Fig.: B-9 If the internal rechargeable battery of the control computer
is empty, “Attach to bike” will be displayed during activation.
To Next Page
Loading...
Need help?
General
