44
Operation
Control computer
The control computer is equipped with the following buttons.
-
button: Switch the control computer or the e-bike on and off
(see chapter “Operation > E-bike”).
-
button: To configure and access your current settings and
your user profile in the operational mode “Settings > My Nyon”
(see chapter “Operational modes in the main menu”).
-
button: Switch the lighting on and off (see chapter
“Operation > E-bike > Lighting”).
- Joystick
: Navigating through the operational modes
(see chapter “Joystick”).
Joystick
Displaying the main menu
1. Move the
joystick to the left to display the main menu.
The main menu will be shown on top of the active operating
mode (see Figure B-25).
2. Push the joystick to switch to the main menu
.
Selecting the operational mode
1. To switch the operating mode, move the
joystick up or down.
2. Push the joystick to select the operating mode.
Setting the operational mode
1. Move the
joystick to the right.
The available settings will be shown on top of the active oper-
ating mode.
2. To switch the setting, move the joystick up or down.
3. Push the joystick to select the setting
.
NOTICE: If you take the board computer out of the holder, all values
for the functions will remain saved and can be subsequently
displayed.
Fig.: B-25 The main menu is shown via the operational mode that
is currently set
To Next Page
Loading...
Need help?
General
