Use only power supply units that can bridge a half-wave failure (10 ms).
10.5.2 Power connector XD10
The control is supplied via the XD10 plug.
Connect the power connector with cables with a conductor cross-section of AWG 16
(1.5 mm
2
).
Use only copper wires to connect the connection terminals.
Use only cables approved for temperatures of at least 60°C.
Only the power connector is permitted to connect the 24 V supply voltage for the control (see
⮫ Chapter 5.1 “Power connectors, 24 V” on page 11).
Fig. 12: Power connector XD10
Table 13: Pin assignment of the power connector XD10
Plug contact Signal Function
1 24 V +24 V DC supply voltage (U
L
)
2 0 V GND (U
L
) (ground supply voltage)
Mounting notes:
•
For the XD10 plus, one-wire cables and stranded cables can be used with or without wire end fer-
rule.
• The cable cross-section allowed is between 0.25 and 1.5 mm (AWG 24 to 16).
• Die stripping length is 8 mm.
•
If stranded cables are used without wire end ferrules, press the pushbutton of the spring clip when
introducing the slightly twisted stranded cable.
• To remove the cables, press the pushbutton of the spring clip.
10.5.3 24 V voltage supply
The voltage supply (SELV) for the device has to be equipped with a UL-approved overcurrent
protection acc. to UL 61010-1, table 18.
For the voltage supply, use a power supply unit as described in the following chapter:
⮫ Chapter 10.5.1 “External power supply unit ” on page 23
To Next Page
Loading...
Need help?
General
