Overview on target groups and product phases
1 About this documentation
1.1 Change record
Table 1: Editions of this documentation
Edition Release date Note
Edition 01 2020-10 First edition
Edition 02 2020-12 Revision
Edition 03 2021-07 Variant X2 supplemented, notes supplemented
1.2 Overview on target groups and product phases
In the following illustration, the framed activities, product phases and target groups refer to the present
documentation.
Example: In the product phase “Mounting (assembly/installation)”, the target group “Mechanic/electri-
cian” can execute the activity “install” using this documentation.
Presales Aftersales
Selection
Mounting
(assembly/installation)
Engineering
Commissioning
Operation
Decommissioning
Product
phases
Target
groups
Activities
Design engineer
Programmer
Technologist
Process
specialist
Select
Prepare
Design
Construct
Mechanic/
electrician
Unpack
Mount
Install
Programmer
Commissioning engineer
Parameterize
Program
Configure
Simulate
Technologist
Process specialist
Optimize
Test
Machine
operator
Maintenance
technician
Service
Operate
Maintain
Remove
faults
Create the
NC program
Mechanic/
electrician
Disposal company
Dismount
Dispose
Fig. 1: Assigning the present documentation to the target groups, product phases and activities of the
target group
This document instructs the technical staff of the machine manufacturer on how to safely perform the
mechanical and electrical installation and on how to commission the device.
Required qualification: Individual who is able to assess the tasks assigned and to identify possible
safety risks owing to qualification in the subject, knowledge and experience. The individual should also
be familiar with the standards and regulations.
To Next Page
Loading...
Need help?
General
