In case of non-compliance with this safety instruction, minor or moderate injury
could occur.
In case of non-compliance with this safety instruction, property damage could
occur.
3.3 Symbols Used
Notes are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.
4 Intended Use
The IndraControl VR 21 devices by Bosch Rexroth are machine operator panels
that can, depending on the application, visualize control data and trigger func-
tions at the machine.
Danger of destruction of the device if not ex-
pressly stated accessories, mounting parts and
other components, cables, lines, software and
firmware are used
The machine operator panels may be used only as intended and with the acces-
sories, mounting parts, and other components specified in this documentation.
Components that are not expressly mentioned must neither be attached nor
connected. The same applies to cables and lines.
Operation must only be carried out with the hardware component configura-
tions and combinations that are expressly specified and with the software and
firmware indicated and specified in the respective documentation and function-
al descriptions.
Typical areas of application of the machine operator panels are:
ā Handling systems and assembly systems
Bosch Rexroth AG
Intended Use
VR 21
4/29
DOK-SUPPL*-VR21**.01**-IT02-EN-P
To Next Page
Loading...
Need help?
General
