14 en | Operation with ICON LCD Codepad Control Panel
2017.09 | 04 | F.01U.298.028 User's Guide Bosch Security Systems, Inc.
5.1.5 Programming STAY Mode 2 Bypass Zones
Programming zones to be automatically isolated in STAY Mode 2 are only carried out if you
have a Master Code or Installer Code.
How to Program STAY Mode 2 Zones
1. Enter your Master Code or Installer Code, followed by [4] and the [#] button (for
example, followed [25804#]). Three beeps sound and the STAY indicator flashes.
2. Enter the zone number to be automatically isolated, followed by the [*] button (for
example, [1*] = Zone 1, [2*] = Zone 2). The selected zone flashes. If you make a mistake,
enter the same zone number followed by the [#] button to clear the incorrect zone. To
select additional zones to be automatically isolated in STAY Mode 2, repeat Step 2 as
many times as required.
3. Press the [#] button to exit this mode when you finish selecting all zones to be
automatically isolated in STAY Mode 2. Two beeps sound and the STAY and AWAY
indicators turn off.
5.2 Disarming the System
When you enter the premises after the system is armed in AWAY mode, or if you armed the
system in STAY Mode 1 or STAY Mode 2, you must disarm the system to disable detection
devices that activate an alarm.
If there was an alarm condition prior to disarming the system, a flashing zone indicator
displays, indicating a previous alarm on that zone.
How to Disarm the System
Enter your user code followed by the [#] button (for example, [2580#]). Two beeps sound.
5.3 Arming/Disarming Areas
The control panel can be partitioned into two individual areas. User codes with authority levels
can arm/disarm each area or both areas from the area codepads.
This feature is only applicable if your installer assigned the zones, codepads,and user codes to
Area 1 , Area 2 or both areas.
How to arm both areas in AWAY Mode
This feature is only applicable if your installer programmed the user codes allowed to arm/
disarm both areas at same time.
Enter your user code followed by [0] and the [#] button ( for example, [25800#]). Two beeps
sound and the AWAY indicator displays. Exit Time starts counting.
How to disarm both areas
Enter your user code followed by [0] and the [#] button ( for example, [25800#]). Two beeps
sound and the AWAY indicator extinguishes.
How to arm Area 1 or Area 2 in AWAY Mode
Enter your user code followed by [0][1] and the [#] button ( for example, [258001#]) to arm
Area 1; or enter your user code followed by [0][2] and the [#] button ( for example,
[258002#]) to arm Area 2. Two beeps sound and the AWAY indicator displays. Exit Time starts
counting.
How to disarm Area 1 or Area 2 in AWAY Mode
Enter your user code followed by [0][1] and the [#] button ( for example, [258001#]) to
disarm Area 1; or enter your user code followed by [0][2] and the [#] button ( for example,
[258002#]) to disarm Area 2. Two beeps sound and the AWAY indicator extinguishes.
To Next Page
Loading...
Need help?
General
