16 en | Operation with ICON LCD Codepad Control Panel
2017.09 | 04 | F.01U.298.028 User's Guide Bosch Security Systems, Inc.
2. Enter the RADION keyfob number (301 to 332) you want to add, followed by the [#]
button. Up to 32 RADION keyfobs can be added, but only current keyfob number (1 to 16)
displays through zone indicators on the ICON codepad.
3. Use manual mode or auto-learn mode to configure RADION keyfob RFID.
– In manual mode, enter the 9-digit RF device ID number, followed by the [#] button.
– Or press [#] button to switch into auto-learn mode. When icon numbers (1 to 16)
flash, press button 1 or 2 of the keyfob. The panel learns the RADION Keyfob ID
number and the last digit of RFID number displays on the codepad. Press [#] button
to confirm.
4. Enter [#] button to confirm the operation, or press [*] to cancel.
5.4.2 Deleting User/Radio Codes
Only the Master Code holder can delete other system user codes.
How to Delete a User Code
1. Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).
Three beeps sound and the STAY and AWAY indicators flash.
2. Enter the user code number (1 to 32), followed by the [#] button (for example, [2#] =
User 2, [16#] = User 16). Two beeps sound and the selected user number displays on the
codepad indicators.
3. Press the [*] button to delete the selected User Code. Two beeps are heard and the STAY
and AWAY indicators turn off.
To delete other User Codes, repeat this procedure as many times as required.
How to Delete a WE800EV2 Keyfob
1. Enter your Master Code, followed by [1] and the [#] button.
2. Enter the WE800EV2 keyfob number (301 to 332) you want to delete, followed by the [#]
button.
3. Press the [*] button to delete the WE800EV2 Keyfob.
How to Delete a RADION Keyfob
1. Enter your Master Code, followed by [1] and the [#] button.
2. Enter the RADION keyfob number (301 to 332) you want to delete, followed by the [#]
button.
3. Press the [*] button to delete the RADION Keyfob.
5.5 Codepad Alarms
5.5.1 Codepad Duress Alarm
A codepad duress alarm is used as a silent hold-up alarm. This only occurs when the number 9
is added to the end of any valid user code being used to disarm the system (for example,
[25809#]). A duress alarm is only useful if your system is reporting back to a monitoring
station. Domestic reporting (such as a mobile phone) cannot decipher which type of alarm
occurred.
5.5.2 Codepad Panic Alarm
An audible alarm activates when you press the [1] and [3] keys or the [*] and [#] keys
simultaneously.
Contact your installer to disable the codepad panic alarm function or to silence the codepad
panic alarm.
To Next Page
Loading...
Need help?
General
