Operation instructions | 19US
6 720 646 951 (2011/09)Copyright
5 Operation instructions
5.1 Before using the water heater
B Check that the power is switched on at the circuit
breaker panel.
B Turn on the hot water faucet FULLY.
• If the unit has been used recently, run the water
through for a few seconds to let the temperature cool
down. You may initially get a short burst of very hot
water that was in the plumbing lines from previous
use.
• If a second outlet connected to the unit is also turned
on, the hot water will be shared between the two.
WARNING:
B Do not use the unit if you think it may be
frozen, as this could result in serious
damage to the unit. Wait until you are
sure that it has completely thawed out
before you switch it on.
The hot water temperature can be changed
by adjusting the temperature dial on the
bottom surface of the unit. (The dial adjusts
the temperature typically between 95°F and
131°F. The factory sets the temperature dial
at the lowest position).
To Next Page
Loading...
Need help?
General