~
Longitudinal feed (Y axis) (1)
1}
Apply grease
to
theY-retainer
0 and respectively place
the
steel balls (5/32") @ on
it.
Fit them
into
the
Y -feed
guide@
so
that
no steel balls (5/32")@ drop
out
of
theY
-retainer
0.
2)
Make
the
back
of
Y-feed guide @ touch mounting reference plane
of
the
X-feed bracket a and secure
them
with
the
bolt.
3)
Put
theY-feed
bracket
€)
between
theY-feed
guide@
attached
to
the
X-feed bracket a and another
Y-
feed bracket@. Then attach the X-feed bracket@
to
the X-feed bracket a
with
the
bolt.
4}
Attach
theY
-stoppers@
to
the
back and
front
of
theY
-feed
guide@
with
the
screws G.
NOTE:
At
this time, the screw G
of
theY-stoppers@ should
be
temporarily tightened.
5)
Attach the
bolt@
for
adjustment and
the
nut@
to
the
X-feed bracket
a.
6)
Make
theY-retainer
0 touch
theY-feed
stoppers@. Adjust
theY-feed
guide@
by pressing
the
bolt@)
attached
to
the
X-feed bracket
€)
so
that
theY
-feed bracket
€)
has
no slack and smoothly moves
at
10
kg
or
less.
Then, secure
theY
-feed bracket@
with
the
bolt.
After
adjustment,
the
bolt
@ should be secured
with
the
nut
@)when
it
slightly touches
the
back
of
the
Y -feed bracket
@.
7}
After
above adjustment
is
made, secure theY-stoppers
@)
at
the
back and
front
of
theY-feed
guide @
with
the
screws G.
-37-
To Next Page
Loading...
Need help?
General
