Brother BAS-304 Service Manual

ASSEMBLY
[1] Thread tension
---~--~
-··- . 1·· I
.:-----::::::··- ' :
~__:_--,! .
' _j ,.
---~ .
·-~-- .. __ _)
Setser~ l'l~l»>
1) Attach the presser bar lifter rod@) to the joint 0 with the stud screw 0 and the nut@.
Attach the presser bar wire assembly 0 to the presser rod lever assembly €) with the stop ring fl. Then
insert
them from the top of the arm.
2) Insert the shaft part of the thread tension bracket assembly@ into the arm, and tighten the screw@).
3) Attach the air cylinder«!) to the arm with the two screws ID.
4) Insert the pin@ of the presser rod lever assembly@) into the arm hole, then tighten the set screw®.
5) Attach two urethan tubes (R) ([;}to M5-05 elbows@.
6) Fit the presser bar wire assembly 0 in the cord holder NK-3N 0 and the wire holder tiD. Then tighten the
screws@.
7) Attach the tension release bar @!>,the pin ID and the thread tension assembly 0 to the machine body,
place
the set screw in the groove of the thread tension assembly 0, then tighten it.
-21-.
From the library of: Superior Sewing Machine & Supply LLC

Brother BAS-304 Specifications

General

Brand	Brother
Model	BAS-304
Category	Sewing Machine
Language	English