Align the red dot on this type of hood with
the notch in the bayonet mount at the front
of the lens. Then lightly push the
hood
into
the mount and turn
it
until
it
is tight.
vvnen nor
in use, rne nwu
can
ue
mounted in reverse on a standard or rome
wide-angle lenses, in which case even the hood
will fit perfectly into the camera's case.
4
Mountina onto the Camera and
I
~ismousin~
Pre-Mounting Checklist
1.
Make sure the camera's stop-down lever
is
not locked for stoppeddown metering (see
p.
55).
If it is, a red warning dot will appear
beside the coupling lever inside the camera
body.
2.
Make sure the automatic aperture lever at
the rear of an
FD
lens
is
not
set
for manual
diaphragm control
(See P.
56).
3.
Before mounting an
FD
lens, make sure
To Next Page
Loading...
Need help?
General
