60
IV.
OTHER
INFORMATION
1. Remove the batteries, wipe the battery terminals and reload them.
Check the batteries again.
If
the
be
indicator still appears, replace
the batteries with new ones.
2. Release the shutter once.
If
the
be
indicator goes out, the problem
is
corrected and you can
continue using the camera normally. If the
be
indicator does not
stop, the camera needs to
be
examined by
an
authorized Canon ser-
vice facility.
3) Lithium Battery Information
Always check the batteries at the following times:
1. When loading new batteries
2. After lengthy storage
3.
If
the shutter will not release
4.
In
cold weather
5. Before
an
important shooting assignment
Battery Use Information
• Wipe the battery terminals with a clean, dry cloth to ensure proper con-
tact.
• The batteries may explode or cause burns if disassembled, recharged,
shorted, exposed to high temperatures, or disposed of
in
fire.
Be
sure
to observe all precautions indicated
on
the battery package. Always
keep it out of the reach of children.
• Battery performance deteriorates slightly
in
temperatures below ao
c.
Keep the camera and especially a spare battery close to your body or
in
an
inside pocket
to
keep
it
warm until use.
• Remove the batteries
if
you do not expect to
use
the camera for more
than three weeks.
4) Camera Operation with Low Batteries
Even if the
be
indicator appears in the LCD panel during battery
check, exposure will be okay as long as the shutter releases. Film
advance and rewind will be impaired by insufficient battery power.
Please replace the batteries with new ones.
To Next Page
Loading...
Need help?
General
