Job Build
4-50
4
Special Copying and Mail Box Features
Job Build
This mode enables you to scan originals that are too many to be placed at once, by dividing
them into multiple batches. You can use both the feeder and the platen glass for scanning. The
originals are printed as one document after all of the batches have been scanned.
IMPORTANT
•
You cannot change the copy settings while the machine is scanning originals in the Job Build mode. You
need to set the necessary copy/scan settings beforehand, according to the type of originals or the
desired result.
•
If you place your originals in the feeder, remove the originals from the original output area when the
scanning of each batch is complete.
•
When copying, you can change or specify the following settings before scanning the next batch of
originals (i.e., between batches): the number of copies, Two-sided Original mode, original type, and
copy exposure. However, if you specify the Image Combination mode with the Job Build mode, you
cannot change the copy exposure and original type.
•
When storing a document in an inbox, you can change or specify the following settings before scanning
the next batch of originals (i.e., between batches): the 2-sided Original mode, original type, scan
exposure. However, you cannot change the original type and scan exposure while the machine is
scanning originals in the Image Combination mode.
Originals
Copies
To Next Page
Loading...
Need help?
General
