29
Choose either or by pressing the
COMPUTER 1 or COMPUTER 2 button on the remote controller.
Before using these buttons, correct input source should be selected through Menu operation as
described below.
1
2
3
When the Auto input function is set to On 1 or On
2 in the Auto setup function, the input signal will
be searched automatically (p.47).
COMPUTER 1
Press the MENU button to display the
On-Screen Menu. Use the Point ▲▼
buttons to select and then press the
Point ► button or the OK button.
Use the Point ▲▼ buttons to select
COMPUTER 1.
When COMPUTER 1 is selected, press
the Point ► button to access the submenu
items. Use the Point ▲▼ buttons to select
the input source and then
press the OK button.
Direct Operation
Menu Operation
OR
Use the Point ▲▼ buttons to select
COMPUTER 2 and then press the OK
button.
To Next Page
Loading...
Need help?
General
