Choose or
by pressing the COMPONENT or
the COMPUTER 1 button on the remote controller.
Before using these buttons, correct input source should be selected through Menu operation as
described below.
1
2
Use the Point ▲▼ buttons to select
COMPUTER 1 and then press the Point ►
button.
When the input source is coming
from video equipment connected
to the COMPUTER IN 1/S-VIDEO
IN/COMPONENT IN terminal
with a COMPONENT-VGA Cable,
select .
When the input source is coming
from video equipment connected
to the COMPUTER IN 1/S-VIDEO
IN/COMPONENT IN terminal
with a Scart-VGA Cable, select
.
Press the MENU button to display the
On-Screen Menu. Use the Point ▲▼ buttons
to select and then press the Point ►
button or the OK button.
When the Auto input function is set to On 1 or On
2, the input signal will be searched automatically
(p.47).
3
Use the Point ▲▼ buttons to select
or and then press the
OK button.
Direct Operation
Menu Operation
Press the Point ▲▼ buttons
to select or
.
To Next Page
Loading...
Need help?
General
