38
Choose VIDEO or by pressing the
INPUT button on the top control, or the VIDEO or
the S-VIDEO button on the remote controller.
Before using these buttons, correct input source
should be selected through menu operation as
described below.
1
2
VIDEO
Direct Operation
When video input signal is
connected to the VIDEO jack, select
VIDEO.
VIDEO
When the Auto input function is set to On 1 or On
2 in the Auto setup function, the input signal will be
searched automatically (p.47).
Press the MENU button to display the
On-Screen Menu. Use the Point ▲▼ buttons
to select and then press the Point ►
button or the OK button.
Use the Point ▲▼ buttons to select VIDEO
or, and then press the OK button.
VIDEO
Menu Operation
When video input signal is
connected to the S-VIDEO jack,
select .
To Next Page
Loading...
Need help?
General
